American hose clamps are widely used in automobiles, petrochemicals, pharmaceuticals, food brewing, sewage treatment, purification, dust truck parts and other machinery, especially suitable for high and medium models or corrosive material parts. The throat has anti-torsion, locking, adjustment range, and can be used to connect soft and hard pipes above 30mm. In order to promote the effect of sealing, throat pipes and clamping support end pipes, the actual project should not directly replace ordinary pipes, and the verticality of the plane and the axis itself have certain requirements.

   American hose clamps: When the clamp position information is determined, the size of the gap between the two pipe ends should be determined by analytical calculation methods based on the elongation of different pipes and the environment and temperature data during construction. When laying, avoid sharp objects and various oils. When laying the hose vertically to a high place, use the hose hook. When laying the hose by raising the main transportation road, the hose bridge should be padded. When passing through the Chinese railway, in order to remove the grease on the hose, it can be washed with warm water or soap. For frozen hoses, we must first use it to melt, and then clean and dry it. The hose that is not fully dried should not be rolled up for storage. When choosing, as a consumer, you need to compare prices from three stores, and you also need to know that this type is also different and the effects are not the same. After clarifying your own needs, choose some that can meet your needs, and measure and compare the quality and quotation methods in various aspects of the society. After knowing the advantages of different hose hoops, choose the best one.

       Failure and troubleshooting of American hose hoops

The failure of American hose hoops mainly occurs in the phenomenon of weak tightening caused by damage. British throats are generally unable to tighten, the tightening force is weak or the expected effect is not achieved. The elimination method of the British throat is as follows: 

1. Due to various reasons, the steel belt needs to be removed for installation, but sometimes we cannot buckle it. The elimination method is that the steel belt and the throat are not on the same horizontal plane, so that the steel belt and the throat are in a straight line. 

2. Troubleshooting of weak links in the tightening process. When tightening, the throat belt will not shrink. In this case, the throat belt is damaged or the throat screw is damaged. In this case, a new throat belt should be replaced. Troubleshooting method for American throat clamps: The failure of the American throat clamp is manifested as weakness during tightening, which is a buckle injury caused by improper operation. The solution is to put a flat pad on the screw part of the throat clamp, and by staggering the position of the nut, the buckle injury can be used normally. The American throat clamp rarely has buckle injuries, mainly due to improper operation causing the steel belt to break. Solved by replacing a new throat clamp. Troubleshooting method for wire throat clamps, the failure of wire throat clamps is also reflected in the screws. After the steel throat clamp turnbuckle is damaged, the tightening will be heavy and will not achieve the expected effect.

 To eliminate this problem, remove the screw and clamp it in a vise, and the turnbuckle needs to be used upward to repair it. Use a 6mm diameter plate support to rotate to the bottom. The screw has been repaired and can be used normally when installed on the steel hose clamp.